In view of the special radiation protection function of the radiation protection door, pay attention to the following small installation skills during the specific construction:
1. Put the radiation protection door into the door opening (remove the door leaf if necessary), make the inner surface of the edge of the radiation protection door and the contact surface fit the wall and vertical, and correct the surface of the wall if necessary.
2. For the vertical positioning of the side frame of the radiation protection door, the point plane must be on the same plane
3. The hinged side frame of the radiation protection door shall be fixed, blasted, fixed or clamped firmly.
4. Adjust the vertical position of the lock position wide body to make the gap between the door leaf and the door frame uniform and make the final fixation.
5. After the cement slurry or styrofoam is dried, remove the clearance piece and its base plate.
6. The most important thing is to check the ray protection door that needs to be installed, check whether its switch is flexible and smooth. After confirming that the door switch is smooth, use lead plate or barium sulfate protective coating to seal the door wall and the door wall gap, so as to ensure that the ray does not leak.
This article is dedicated to radiation protection equipment. For more information, please click: Sincere attitude. For you to provide a comprehensive service. More relevant knowledge we will continue to dedicate to you. Please look forward to